JOINT COMPOUND HYLOMAR 80ML

Hylomar is a highly engineered, non-setting and non-hardening gasketing compound.
The compound is resistant to a wide range of fluids including industrial fuels, oils, water and brine, air, turbine and piston engine combustion products, water, water/glycol and methanol mixtures, petroleum and synthetic diester lubricating oils, gasoline, kerosene fluids (Avtur and Avcat) and fluorocarbon refrigerants.
Hylomar can be used to seal both joint surfaces and threaded parts and can operate at temperatures between -50°C and up to 250°C (-58°F and 482°F).

Instructions for use:
The joint faces should be clean and dry.
Both faces should then be coated with a thin, even film of the product, and the solvent allowed to evaporate.
The components can then be assembled.
Since Hylomar is non-setting, once applied to the faces of the component, immediate assembly is not required.
Due to the nature of Hylomar, re-torquing of assembled components may be required.
For stud loading, torque to required figure, allow compound to settle for a few minutes, then re-torque.

Applications:
Hylomar enables the effective sealing of metal-to-metal, and plastic-to-plastic components.
Typical applications include water and oil pumps, instrument inspection covers, cylinder heads and sumps, coating pre-formed gaskets, weather proofing motors and outdoor high voltage circuit breakers inlet manifolds, timing case covers, oil pump joints, gear box and transmission components, and thread sealing.
It has also been successfully used in the assembly of gas turbines, water cooled generators and turbo vacuum systems.
There is no straining of copper and silver etc. from traces of volatiles at elevated temperatures and is therefore suitable for joints and threads near to switch mechanisms.